9
press D. If a valid Arm/Disarm code is entered,
the keypad will beep 6 times, indicating the
panel has been disarmed. The red Armed LED
will go out. If an incorrect Arm/Disarm Code is
entered, the keypad will sound a 1-second tone,
indicating incorrect entry. Press the
C key
and re-enter the code.
Disarming after an Alarm
(Alarm Memory)
The armed LED and the zone(s) that caused the
alarm will be flashing. Disarm the panel. The
system is currently not detecting zone faults or
displaying system trouble. The zone(s) that
caused the alarm will continue to flash. The
STATUS and
H SYSTEM TRBL LED's are out
indicating:
• The system is displaying Alarm Memory.
Press the C key to clear Alarm Memory.
Bypassing
Automatic Bypassing
Home/Away with Delay Zones
This zone type has the following operation de-
pending on whether an Exit/Entry Zone has
been violated during the Exit Delay time.
Home
Exit/Entry Zone is not violated
Zones selected as Home/Away with Delay
Zones will be bypassed automatically.
Away with Delay
Exit/Entry Zone is violated
Zones selected as Home/Away with Delay
Zones will have a fixed 20-second entry
delay when violated before an Exit/Entry
Zone.
Full Setting the System with Automatic
Bypassing - Home/Away with Delay
Zones
From the Keypad
Press BC to return protection to
Home/Away with Delay Zones that have
been automatically bypassed. Three min-
utes are allowed to walk through Exit/Entry
and Exit/Entry Follower Zones.
Using A Keyfob (GEM-KF)
All zones in the system can be armed re-
gardless of the state of the Exit/Entry Zone
when arming with a Keyfob and using an
AUX key programmed as Full Set. Press
K and press and hold the M or N
keys for 1.5s when leaving the premises. All
zones, including Home/Away Zones are
armed..
Bypassing a zone
Press the B key, then the zone number to be
bypassed. While the panel is DISARMED, the
bypassed zone LED will flash slowly; indicating
the zone has been bypassed. While the panel is
ARMED, the bypassed zones will only be dis-
played if the Display Bypassed [21-3] option has
been selected.
Unbypassing a zone (Disarmed only)
Press the B key then the number of the
zone to be unbypassed.
Group Bypass
Press the E key to Bypass all Exit/Entry
Follower Zones [02] or Home/Away Zones
[01] (only if the system is programmed ex-
clusively for Home/Away with Delay
zones).
.
Using A Keyfob (GEM-KF)
Hold the M or N key on the Keyfob to
Bypass all Exit/Entry Follower Zones [02] or
Home/Away Zones [01] (only if the system is
programmed exclusively for Home/Away
with Delay zones).
User Program Mode
To prevent the loss of the User 1 Code, the
panel default program includes User 1 Code
Lockout [96-2].
To change the User 1 Code from its default
To Next Page
Loading...
Need help?
General
