CHANGES FROM PREVIOUS EDITION
The following changes have been made to this manual (WI817F) since the last edition (WI817E).
This version of the manual reflects the addition of two new NAPCO products:
• The Access Control system (ACM), which provides integrated access control to the burglary alarm functions of the
GEM-X255 control panel.
• The NAPCO NetLink™ system that allows the reporting of alarms over a TCP/IP based (Intranet or Internet) net-
work.
• Page 30, new Keypad messages (System Troubles) added to accommodate the new ACM and NetLink™ systems.
• Page 17: Correction--"Two-wire smoke detectors may be connected to control panel zones 7-8". Page 18 also
removed the incorrect wiring diagram and accompanying text.
THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN CONTROL PANEL FIRM-
WARE VERSION 50 OR LATER.
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
NOTE: Upon entering program mode, the keypad display will flash the control panel firmware version, followed by the
keypad firmware version:
GEM-RP1CAe2: [2006], GEM-RP2ASe2: [205b], GEM-RP3DGTL: [20/1C]
For consistency, it is recommended that all keypads either be all "classic" (such as the GEM-RP1CAe2 key-
pad) or all "K Series" (such as the GEM-K1CA)--both keypad types should not be used in one alarm system.
To Next Page
Loading...
Need help?
General
