X GEM-P3200 Installation Instructions
L NAPCO Security Systems
WI817F 10/05
Page 4
TABLE OF CONTENTS
Refer to accompanying GEM-P3200 Programming Instructions (WI818 and WI1184) for programming information.
CHANGES FROM PREVIOUS EDITION ........................ 2
IMPORTANT NOTE ......................................................... 3
INTRODUCTION .............................................................. 5
General Description ............................................ 5
Features .............................................................. 5
Specifications ...................................................... 7
Ordering Information ........................................... 7
Summary Of UL Requirements ........................... 9
INSTALLATION ............................................................. 10
Mounting ........................................................... 10
Wiring ................................................................ 11
Wireless Systems .............................................. 11
Typical Residential Fire Installation ................... 11
Typical Partitioned Installation .......................... 11
UL Commercial-Burglary Installations ............... 12
Testing The System .......................................... 13
WIRING CONNECTIONS .............................................. 14
Battery ............................................................... 14
Transformer ....... ........................ .................... .... 14
Siren/Bell Alarm Output ..................................... 14
Auxiliary Alarm Output ...................................... 14
Remote Bus ...................................................... 15
Earth Ground ..................................................... 15
Auxiliary Power ................................................. 15
Reset Output ..................................................... 16
Basic Zone Configuration .................................. 16
Expanded Zone Configuration .......................... 16
4-Wire Smoke Detectors ................................... 17
2-Wire Smoke Detectors ................................... 17
Telephone Lines ................................................ 18
KEYPAD CONFIGURATION MODE ............................. 19
Keypad Installation ............................................ 19
Configuring the Keypads ................................... 19
BASIC OPERATION ...................................................... 22
User Codes & Zone Descriptions ...................... 22
Arming and Disarming the System .................... 23
Bypassing Zones ............................................... 25
Alarm Indication ................................................ 26
Function Mode .................................................. 26
Keypad Messages ............................................. 30
GLOSSARY ................................................................... 31
STANDBY-BATTERY CALCULATION WORKSHEET 53
WIRING LEGEND .......................................................... 54
KEYPAD PROGRAMMING MODES ............................. 55
GEM-P3200 WIRING DIAGRAM ................................... 60
CP-01 QUICK REFERENCE CHART-SIA .................... 61
FACTORY DEFAULT DESCRIPTION .......................... 63
STATEMENT FOR CANADIAN MODELS .................... 64
FCC STATEMENT ......................................................... 65
LIMITED WARRANTY ................................................... 68
NOTE: THESE INSTRUCTIONS ARE INTENDED AND WRITTEN FOR PROFESSIONAL INSTALLATION PERSONNEL HAVING SUITABLE
TRAINING, EXPERIENCE AND INSTALLATION EQUIPMENT. IT IS RECOMMENDED THAT AFTER PROGRAMMING, THE ERROR CHECK
UTILITY OF THE PCD3000 (OR PCD-WINDOWS) DOWNLOADER SOFTWARE BE USED TO VERIFY THAT THE CONTROL PANEL PRO-
GRAM CONTAINS NO ERRORS OR CONFLICTS WHICH MAY INHIBIT ITS INTENDED OPERATION.
To Next Page
Loading...
Need help?
General
