Napoleon PRO665 - Troubleshooting; Burner and Flame Issues; Ignition and Lighting Problems

www.napoleongrills.com
17
EN
WƌŽďůĞŵ WŽƐƐŝďůĞĂƵƐĞƐ ^ŽůƵƟŽŶ
Infrared burner ;if
equippedͿ Ňashes
bacŬ ;during operaƟon
the burner abruptly
maŬes a loud whoosh
sound, followed by a
conƟnuous blow-torch
type sound and grows
dim.Ϳ
Ceramic Ɵles oǀerloaded with grease
drippings and build-up. Ports are
clogged.
Burner oǀerheated due to inadequate
ǀenƟlaƟon ;too much grill surface
coǀered by griddle or pan.Ϳ
CracŬed ceramic Ɵle.
LeaŬing gasŬet surrounding the ceramic
Ɵle, or a weld failure in the burner
housing.
durn burner oī and allow to cool for at least
two minutes. Relight burner and burn on high
for at least Įǀe minutes or unƟl the ceramic
Ɵles are eǀenly glowing red.
Ensure that no more than 75й of the grill
surface is coǀered by objects or accessories.
durn burner oī and allow to cool for at least
two minutes, then relight.
Allow burner to cool and inspect ǀery closely
for cracŬs. If any cracŬs are found, contact
your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for
instrucƟons on ordering a replacement burner
assembly.
Electronic IgniƟon not
worŬing.
hnit not connected to power.
Blown Fuse.
Faulty transformer.
derminals on switch or circuit board are
corroded or loose.
Faulty igniter.
Dirty or corroded electrodes.
Plug power cord ;from worŬing GFI protected
outletͿ into electrical bodž on the bacŬ of the
grill. Plug transformer cord into power bodž.
Replace fuse located on outlet line of
transformer.
ChecŬ transformer output – should be 12sAC.
Replace if required.
Clean connecƟons and ensure connectors are
pushed together Įrmly. Access to circuit board
is under electrical coǀer on leŌ side of cabinet.
Replace igniter – located under electrical coǀer.
Clean or replace as required.
Oǀen and control panel
lights not worŬing
hnit not connected to power.
Blown fuse.
Faulty transformer.
derminals on switch or circuit board are
corroded or loose.
Bulbs blown ;oǀen lights onlyͿ.
Plug power cord ;from worŬing GFI protected
outletͿ into electrical bodž on the bacŬ of the
grill. Plug transformer cord into power bodž.
Replace fuse located on outlet line of
transformer.
ChecŬ transformer output – should be 12sAC.
Replace if required.
Clean connecƟons and ensure connectors are
pushed together Įrmly. Access to circuit board
is under electrical coǀer on leŌ side of cabinet.
Replace bulbs as per the instrucƟons in the
maintenance secƟon of the manual.