5.4 Changing the instrument settings
Narda NBM-520 41
5.4 Changing the instrument settings
Changing the instrument settings
1. Establish a connection between the instrument and PC
(see “Working with the PC software” on page 40).
2. Start the software.
3. Select the Configuration tab and activate the
connection via the Connect icon.
4. Select the Setups tab.
5. Set the values as required.
You can alter the following values (see “Displaying the
instrument settings” on page 26):
• AUTO-ZERO
•AUTO-OFF
• BACKLIGHT
•AVG TIME
• SPATIAL
• UNIT
• LIMIT FLAT
• LIMIT SHAPED
•ALARM
5.5 Updating the firmware
You can update the firmware of the NBM-520 in order to
make use of new or improved functions.
You can only update the firmware using a PC on which the
NBM-TS PC software has been installed.
Note: The NBM-520 must be supplied with power via the mains
adapter while updating. This prevents the update from being
interrupted due to discharged batteries. The PC software
checks whether an adapter is connected and, if not, dis-
plays a warning.
Updating the firmware
1. Save the latest firmware for the NBM-520 on the PC.
The latest firmware is available from the Narda web site
at http://www.narda-sts.com.
Downloaded from Arrow.com.
To Next Page
Loading...
