Chapter 1 Overview of the FP-20xx Network Module
FP-2000/2010/2015 User Manual 1-4 ni.com
select Download Software»Drivers and Updates»Current Software
Versions»Fieldpoint Explorer, and follow the instructions on that page.
FP-20xx Setup Overview
The following list is an overview of the steps required to get up and running
with your FP-20xx and LabVIEW RT.
1. Install hardware as described in Chapter 2, Installing the Hardware
and Software.
a. Mount FP-20xx, terminal bases, and I/O modules.
b. Connect FieldPoint system to network.
c. Wire power to FieldPoint system.
d. Wire signals to I/O modules.
2. Install the software as described in Chapter 2, Installing the Hardware
and Software.
a. Install programming software (LabVIEW RT).
b. Install FieldPoint Explorer.
3. Configure the FieldPoint system, and verify the configuration,
as described in Chapter 3, Hardware and Software Configuration.
a. Configure FP-20xx network settings.
b. Configure I/O module ranges and settings.
c. Configure security.
d. Test channels.
e. Save settings.
4. Configure optional settings as described in Chapter 4, Feature Set
Description.
5. Develop your application, as described in Chapter 5, LabVIEW RT
Programming.
a. Launch LabVIEW RT.
b. Develop code.
c. Switch execution target to test code on FP-20xx.
d. Build application by building
.exe
with LabVIEW RT targeted to
FP-20xx.
e. Test embedded application.
6. Deploy system.
To Next Page
Loading...
