Chapter 5 LabVIEW RT Programming
© National Instruments Corporation 5-9 FP-2000/2010/2015 User Manual
3. Select Tools»Build Application or Shared Library (DLL) to open
the Build Application or Shared Library (DLL) dialog box, shown in
the following figure.
4. Select Application (EXE) from the Build target pull-down menu.
5. Click the Source Files tab.
6. Click Add Top-Level VI.
7. Navigate to the location of the VI to be added.
8. Select the VI to be added.
9. Click OK.
10. Click Build.
Target Tab
On the Target tab, the Application Builder determines the Target file
name, Destination directory, and Support file directory from the
Application Path setting in Network Options. You cannot change the
Application name, Destination directory, and Support file directory
settings in the Application Builder when you target LabVIEW RT to the
FP-20xx. Refer to the Network Options section for more information about
accessing and using Network Options.
To Next Page
Loading...
