© National Instruments Corporation 5-1 FP-2000/2010/2015 User Manual
5
LabVIEW RT Programming
This chapter contains specific information about targeting LabVIEW
Real-Time (RT) to the FP-20xx module, network options for restricting
access to your module, embedding LabVIEW RT applications on your
module, and launching embedded applications when your module starts up.
For general LabVIEW RT programming information, refer to the LabVIEW
RT User Manual.
Targeting LabVIEW RT to a Platform
You can target LabVIEW RT to your FP-20xx or the host PC. When you
select a target platform other than the host PC, the RT Development System
downloads any LabVIEW RT application you subsequently run to the
selected target platform. Refer to Chapter 1, Introduction, and to Chapter 3,
Software Overview,oftheLabVIEW RT User Manual for more
information about the RT Development System.
Targeting LabVIEW RT to the FP-20xx
When you target LabVIEW RT to your FP-20xx, you can run
LabVIEW RT applications on the controller. However, when targeted to
your FP-20xx, LabVIEW RT lacks some features found in LabVIEW for
Windows because the controller does not have all the software of a PC.
The following LabVIEW functions are not supported in LabVIEW RT
when targeted to your FP-20xx:
• ActiveX
• Front panel datalogging
• Dialog boxes
• Printing
• Programmatic menus
• VISA
• Front panel Web publishing
• NI-DAQ
To Next Page
Loading...
