Appendix E Specifications
FP-2000/2010/2015 User Manual E-2 ni.com
Physical Characteristics
Screw-terminal wiring ............................16–26 AWG copper conductor
wire with 7 mm (0.28 in.) of
insulation stripped from the end
Torque for screw terminals.....................0.5–0.6 N ⋅ m(4.4–5.3 lb ⋅ in.)
Weight ....................................................278 g (9.8 oz)
Environmental
FieldPoint modules are intended for indoor use only.
Operating temperature ............................–25 to 55 °C
Storage temperature................................–
40 to 85 °C
Humidity.................................................10 to 90% RH, noncondensing
Maximum altitude...................................2,000 m
Pollution Degree .....................................2
Safety
The FP-20xx meets the requirements of the following standards for safety
and electrical equipment for measurement, control, and laboratory use:
• EN 61010-1:1993/A2:1995, IEC 61010-1:1990/A2:1995
• UL 3101-1:1993, UL 3111-1:1994, UL 3121:1998
• CAN/CSA c22.2 no. 1010.1:1992/A2:1997
Electromagnetic Compatibility
CE, C-Tick and FCC Part 15 (Class A) Compliant
Electrical emissions ................................EN 55011 Class A at 10 m FCC
Part 15A above 1 GHz
Electrical immunity ................................Evaluated to EN 61326: 1997/A1:
1998, Table 1
Note
For full EMC compliance, you must operate this device with shielded cabling. In
addition, all cover and filler panels must be installed. See the Declaration of Conformity
To Next Page
Loading...
