Chapter 2 Installing the Hardware and Software
© National Instruments Corporation 2-7 FP-2000/2010/2015 User Manual
Mounting the FP-20xx toaPanel
Follow these steps if you choose to install the optional FieldPoint network
panel-mount accessory and mount the FP-20xx network module to a panel.
You can order the panel-mount accessory, part number 777609-01, from
National Instruments.
1. Write down the serial number from the back of the FP-20xx before you
mount it.
2. Use a flathead screwdriver to open the rail clip to the unlocked
position, as shown in the following figure.
3. Snap the panel-mount accessory onto the module, as shown in the
following figure.
4. Lock the panel-mount accessory into place by pushing the rail clip to
the locked position.
1 Rail Clip Locked 2 Rail Clip Unlocked
1 2
To Next Page
Loading...
