National Instruments FieldPoint FP-2000 - Source Files and VI Settings Tabs; Application Settings and Installer Settings Tabs; Launching Embedded Applications at Startup

Chapter 5 LabVIEW RT Programming
FP-2000/2010/2015 User Manual 5-10 ni.com
If you select Small target with external file for subVIs in the Build
Options pane, you cannot change the LLB for other files path because this
path is determined from the Application Path setting in Network
Options. Refer to the LabVIEW Help for more information about the Small
target with external file for subVIs option. Refer to the Network Options
section for more information about accessing and using Network Options.
Source Files and VI Settings Tabs
Use the Source Files and VI Settings tabsthesamewayyoudotobuilda
LabVIEW RT application when LabVIEW RT is targeted to the host PC.
Refer to the LabVIEW Help for more information about the Source Files
and VI Settings tabs.
Caution
Do not add the file
serpdrv
to your application in the Source Files tab.
The serial port driver is installed on the FP-20xx with the RT Engine. Manually adding
serpdrv
to your application adds the Windows driver, which is not compatible with the
LabVIEW RT Engine on the FP-20xx.
Application Settings and Installer Settings Tabs
The Application Settings and Installer Settings tabs are disabled when
you target LabVIEW RT to the FP-20xx because these settings do not apply
to applications embedded on the controller.
Launching Embedded Applications at Startup
The RT Engine can launch your embedded application each time you start
up your FP-20xx. Complete the following steps to launch your embedded
application each time the FP-20xx starts up:
1. Target LabVIEW RT to the FP-20xx. Refer to the Targeting LabVIEW
RT to the FP-20xx section for more information.
2. Select Too ls »Network Options.
3. Select RT Target: Miscellaneous from the pull-down menu.
4. Select Launch Application at Boot-up.
5. Click OK.