National Instruments M Series - Page 395

Index
M Series User Manual I-2 ni.com
analog edge triggering
with hysteresis, 11-4
analog input, 4-1
channels, 11-3
charge injection, C-1
circuitry, 4-1
connecting signals, 4-13
connecting through I/O connector, 4-1
crosstalk when sampling multiple
channels, C-1
data acquisition methods, 4-11
differential, troubleshooting, C-1
getting started with applications in
software, 4-40
ghost voltages when sampling multiple
channels, C-1
ground-reference settings, 4-1
lowpass filter, 4-4
MUX, 4-1
range, 4-2
sampling channels with AI Sample Clock
and AI Convert Clock, C-2
timing diagrams, B-1
timing signals, 4-25
triggering, 4-12
troubleshooting, C-1
analog input data acquisitions, 4-11
analog input range, 4-2
analog input signals, 4-25
AI Convert Clock, 4-31
AI Convert Clock Timebase, 4-35
AI Hold Complete Event, 4-36
AI Pause Trigger, 4-39
AI Reference Trigger, 4-37
AI Sample Clock, 4-28
AI Sample Clock Timebase, 4-30
AI Start Trigger, 4-36
analog output, 5-1
circuitry, 5-1
connecting signals, 5-6
data generation methods, 5-4
fundamentals, 5-1
getting started with applications in
software, 5-12
glitches on the output signal, 5-4
offset, 5-2
reference selection, 5-2
timing diagrams, B-21
timing signals, 5-7
triggering, 5-6
troubleshooting, C-3
analog output signals, 5-7
AO Pause Trigger, 5-8
AO Sample Clock, 5-10
AO Sample Clock Timebase, 5-11
AO Start Trigger, 5-7
analog output trigger signals, 5-6
analog source, triggering, 11-2
analog to digital converter, 4-2
analog trigger, 11-2
accuracy, 11-7
actions, 11-3
improving accuracy, 11-7
analog window triggering, 11-6
ANSI C documentation, xix
AO FIFO, 5-1
AO offset, 5-2
AO offset and AO reference selection
settings, 5-2
AO Pause Trigger signal, 5-8
AO reference selection, 5-2
AO Sample Clock, 5-2
Timebase signal, 5-11
AO sample clock
signal, 5-10
AO Sample Clock signal, 5-10
AO Sample Clock Timebase signal, 5-11
AO Start Trigger signal, 5-7
ao/PauseTrigger, 5-8
ao/SampleClock, 5-10
ao/StartTrigger, 5-7
APFI terminals, 11-2