Native Instruments Guitar Rig Kontrol User Manual

GUITAR RIG KONTROL Hardware Reference – 28
5.2 Hardware Installation
Use the supplied USB cable to connect the RIG KONTROL directly to a USB 2.0 port
on your computer.
The RIG KONTROL is powered via USB. Operation is guaranteed only with a USB 2.0
controller as a single device or with self-powered USB 2.0 hubs.
After successfully installing the driver, the RIG KONTROL should be recognized
automatically. If at any time the computer does not seem to recognize the RIG KONTROL,
disconnect the USB cable, wait a few seconds, then re-connect it. If this does not solve
the problem, restart your computer with the interface connected.
5.3 Conguration
This chapter explains how to use the RIG KONTROL audio interface under Mac OS X and par-
ticularly with the included GUITAR RIG 4. It is assumed that you have already activated GUITAR
RIG 4 using the Service Center – please refer to the Setup Guide for help on this process.

Native Instruments Guitar Rig Kontrol Specifications

General

Brand	Native Instruments
Model	Guitar Rig Kontrol
Category	Music Pedal
Language	English