(2) MASTER knob: Adjusts the volume of the MASTER output signal for the audience. For more
information, refer to Adjusting Levels.
(3) QUANT (Snap) button: Allows you to enable/disable Quantize mode and Snap mode. For
more information, refer to Snap Mode and Quantize Mode.
(4) Master Level Meter: Gives you visual feedback on the current Master Output volume level.
The blue LEDs indicate the signal below Headroom area, and the Red LED indicates the signal is
clipping. The yellow LEDs indicate the signal is currently in the Headroom area above 0 dB and
below +6 dB before it starts clipping.
(5) BOOTH knob: Adjusts the Volume of the Booth Output Signal for the DJ Monitors. For more
information, refer to Adjusting Levels.
(6) MIXER FX SELECT buttons: Select the MIXER FX to be controlled by the individual MIXER
FX controls in the Mixer channels. For more information, refer to Working with Mixer FX.
(7) MIX knob: Adjusts the signal mix between MASTER Output Signal and the CUE Channel in
the headphones. For more information, refer to Using Cue Channel.
(8) VOL knob: Adjusts the level for the CUE channel. For more information, refer to Using Cue
Channel.
(9) Crossfader: Controls the mix between the Mixer channels’ signals assigned to its left and right
side. At each crossfader’s end, the opposite signals are totally cut. Moving the crossfader gradual-
ly fades in and fades out the relevant audio signal in the master output. At the center position, both
audio signals are fully audible. For more information, refer to Assigning Mixer Channels to the
Crossfader.
TRAKTOR KONTROL S4 Overview
23
To Next Page
Loading...
