The Loop size for the enabled Loop instantly changes by the value displayed in the Loop
Control bar.
If there is no Loop enabled, turning the LOOP encoder only predefines the Loop size.
Storing Loop
To store a Loop:
1. Enable a Loop.
2. Press an unlit Pad.
The Loop is stored as a Hotcue. The Pad lights up green.
Triggering Stored Loop
To trigger a stored Loop:
• Press a Pad.
The playback continues at the position of the stored Loop.
Moving Loops
You can move enabled and disabled Loops forward or backward in the track:
• Turn the MOVE encoder clockwise or counter-clockwise.
This instantly moves the Loop in the track.
Tutorials
58
To Next Page
Need help?
General
