Nautilus E618 User Manual

50
Condition/Problem Things to Check Solution
No speed/RPM reading,
Console displays “Please
Stride” error code
Check data cable integrity All wires in cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check magnet position
(requires shroud removal)
Magnet should be in place on pulley.
Check Speed Sensor
(requires shroud removal)
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Resistance does not
change (machine turns on
and operates)
Check Console Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
Check data cable integrity All wires in cable should be intact. If any are visibly crimped or
cut, replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Reseat all connections. Small latch on connector should line up
and snap into place.
Resistance handlebar
connection (requires
handlebar shroud removal)
Be sure cable from left Upper Handlebar and cables to Console
are secure and undamaged.
(E618 only)
Check Servo Motor
(requires shroud removal)
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
MCB (requires shroud
removal)
Replace MCB.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Incline does not adjust
(machine turns on and
operates)
Check Console Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
Incline handlebar
connection (requires
handlebar shroud removal)
Be sure cable from right Upper Handlebar and cables to Con-
sole are secure and undamaged.
Lower and Upper I/O
Cables (requires shroud
removal)
All wires in the cables should be intact. If any are cut or
crimped, replace cable.
Incline Adjuster Assembly
(requires shroud removal)
Be sure Incline Adjuster Assembly is attached to Incline Motor
drive screw.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).

Nautilus E618 Specifications

General

Display	LCD
Programs	29
Heart Rate Monitoring	Contact and telemetry enabled
Bluetooth Connectivity	Yes
User Profiles	4
Maximum User Weight	300 lbs