To Next Page

To Previous Page

1 Installation and Troubleshooting Guide

Table of Contents

1 Installation and Troubleshooting Guide 1

1.1 Introduction 5

1.1.1 Overview 5

1.1.2 Audience 5

1.2 Recommended Installation Practices 6

1.3 Recommended Tools and Supplies 7

1.3.1 Basic Tools 7

1.3.2 Basic Supplies 7

1.4 Qube 300 Hardware 8

1.4.1 Qube 300 Box Contents 8

1.4.2 Qube Installation Supplies Kit (US only) 9

1.4.3 GPS/Cellular Combination Antenna 10

1.4.4 Qube 300 Hardware 11

1.4.5 Qube 300 Security Cover 11

1.4.6 Qube 300 Power Harness 13

1.5 Mounting the Antenna 14

1.5.1 Exposed Install 14

1.5.2 Covert Install 14

1.6 Qube 300 Mounting 15

1.7 Identifying Correct Wires 18

1.7.1 Vehicle's Constant Power wire 18

1.7.2 Vehicle's Ignition wire 18

1.7.3 "Poke &Wrap" Solder-less Connections 20

1.8 Chassis Ground Connection 22

1.9 Mobile Data Terminal: M-Nav 800 23

1.10 ConEx Sensor Monitoring/Auxiliary Devices 25

1.10.1 Digital Inputs DI-1 to DI-4 25

1.10.2 Digital Outputs DO-1 & DO-2 26

1.11 Qube Power Up Procedure 27

1.12 Tamper-Evident Seal 28

1.13 Troubleshooting 29

1.13.1 Qube 300 is not powering up (All LEDs Off) 29

1.13.2 Qube 300 is not reporting in OnlineAVL2 (Cellular Connectivity Issues) 30

1.13.3 Qube 300 is reporting to AVL2 but shows invalid location (GPS Fix Issues) 31

1.13.4 Qube is reporting to AVL2 but displays “Power up + Ignition On” icons. 32

1.13.5 Qube is reporting to AVL2 but does not have any “Ignition Off” events. 32

1.13.6 Qube is reporting to AVL2 but has multiple “Ignition On / Ignition Off” events. 32

1.13.7 Power Cycle/Cold Reset procedure for M-Nav800 33

Navman Qube 300 User Manual

Other manuals for Navman Qube 300