The Stations are listed under the
Terminal icon and show how each
PCI card connects to the stations
(access devices) and their
associated sessions.
To stop or start all sessions at the
same time, right-click on the access
device icon named “X-series” or the
PCI card icon.
To start/stop a Station’s session or
access the station settings (shown
below), right-click on a Station.
Finally, to send a message to a
station or disconnect a station,
expand the Terminals/Station list
and right-click on the Session for a
specific Station.
Note: “Disconnecting” a session will
leave its programs running in the
background, while “Stopping” a
session ends all programs and logs
the session out.
Setting Screen Resolution: You can
set the screen resolution for all
Stations connected to a PCI-card. To
do this, click on the desired X-series
PCI-card in the Terminals list. Right-
click on the X-series card on the right
side of the screen and choose
“Terminal Settings” from the pop-up
menu that is displayed. Choose the
desired screen resolution from the
drop-down menu and then click OK.
To Next Page
Loading...
Need help?
General
