4-92 BIOS Updating Procedure
Option 2 - Update of BIOS - Always enter Serial/Model/Class
This option prompts for Class/Model/Serial information at the beginning of the program
and then updates the BIOS only.
1. Highlight Option 2 and press [ENTER].
2. At the prompt press [ENTER] to enter the Class/Model/Serial Number information
(DMI). Follow the onscreen format instructions.
Example: 7610-1000-8801[ENTER]
54-19378230[ENTER]
3. Press [1] to confirm the data and to continue.
4. The Flash Program updates the BIOS and automatically reboots the terminal.
Option 3 - Update DMI only - Serial/Model/Class update ONLY (no BIOS Update)
This option lets you enter the DMI information only. The BIOS is not updated.
1. Highlight Option 3 and press [ENTER].
2. At the prompt press [ENTER] to enter the Class/Model/Serial Number information
(DMI). Follow the onscreen format instructions.
Example: 7610-1000-8801[ENTER]
54-19378230[ENTER]
3. Press [1] to confirm the data and to continue.
4. Remove the USB device before the system boots.
5. System is ready for operation.
Option 4 - Update BIOS - Default Serial/Model/Class information
This option is for Service Personnel only. It updates the BIOS but leaves the
Class/Model/Serial fields empty (erased). The DMI information is then entered when the
board is installed in a terminal.
1. Highlight Option 4 and press [ENTER].
2. The BIOS are updated and the system reboots.
3. Remove the BIOS Update media before the system boots.
4. System is ready for operation.
To Next Page
Loading...
