NCR 7800 - Power Considerations

,QVWDOODWLRQ&RQVLGHUDWLRQV
8VHUV*XLGH 
The NCR 7800 operates from an internal universal power
supply that connects to the AC power. Different power cords
are available that allow the power supply to support the
following input voltage ranges:
• 104 Vac to 127 Vac, 60 Hz, USA/Canada
• 220 Vac to 240 Vac, 50 Hz, European
• 90 Vac to 104 Vac, 50/60 Hz, Japan
The length of the power cord is 3 feet.
Power supply cord serves as a disconnect device. The
electrical outlet should be installed near the equipment and
should be easily accessible.
/RFDWLRQDQG$FFHVVLELOLW\ $'$*XLGHOLQH
Hallways "Objects projecting from walls, with their leading edges between
27 inches and 80 inches above the finished floor shall protrude no
more than 4 inches into walks, halls, corridors, passageways, or
aisles. (The retailer has to determine if his installation site is
defined as one of these.) Objects mounted with their leading edges
at or below 27 inches above the finished floor may protrude any
amount."
Poles "Freestanding objects mounted on posts or pylons may overhang
12 inches maximum from 27 inches to 80 inches above the ground
or finished floor. Protruding objects shall not reduce the clear
width of an accessible route or maneuvering space."
Mounting Height The first line (top line) of the unit's display should be 47 inches
above the floor.
Power Considerations
Warning:
Compliance with ADA
Guidelines