NCR 7800 - Bar Codes - 1; Upc;Ean; Version D; Extend UPC-A to EAN-13

%DU&RGHV
 8VHUV*XLGH
Bar Codes - 1
Contains programming parameters for UPC/EAN bar codes.
Controls reading of UPC/EAN bar codes. When you are in the
Bar Codes - 1 programming mode, the UPC/EAN function
can be enabled (default) by scanning the
Hex 1
tag and
disabled by scanning the
Hex 0
tag.
If enabled, you can program the following parameters.
Permits you to enable or disable reading UPC Version D bar
codes. There are six choices: None (default), D-1, D-2, D-3,
D-4, and D-5. To select the type of Version D parameter, scan
the appropriate
Hex 0
through
Hex 5
tag. Scanning a valid
Hex tag ends the input for this parameter option.
Determines whether to pad the tag data by putting a zero at
the front of the tag data, changing 12-digit UPC tags to a 13-
character EAN tags. The program does this. Scan the
Hex 0
tag to disable (default) this option or the
Hex 1
tag to enable
it. Scanning a valid Hex tag ends the input for this parameter
option.
Determines whether to pad the tag data, changing 6-digit
truncated UPC tags to 12-character UPC-A tags. Scan the
Hex 0
tag to disable (default) this option or the
Hex 1
tag to
enable it. Scanning a valid Hex tag ends the input for this
parameter option.
UPC/EAN
Version D
Extend UPC-A to
EAN-13
Extend UPC-E to
UPC-A