NCR 7800 - Tone Volume

*RRG5HDG7RQH
8VHUV*XLGH 
procedures starts over, beginning with 25 milliseconds. End
this mode by scanning the
End
tag. However, you can also
end it by scanning another valid Hex tag.
Selects the volume of the Good Read Tone. This parameter
contains seven levels of adjustment from the lowest (0) to the
highest (6).
As with tone frequency, most people cannot decide on volume
levels without listening to them. Therefore, you can set the
tone length by listening to it. When you are at the Tone
Volume programming selection, you can increment the tone
volume by scanning the
Hex A
tag. Each time you scan the
Hex A
tag, the tone volume increments to the next level.
After reaching level 6 (maximum), the procedures starts over,
beginning with volume level 0 (minimum). End this mode by
scanning the
End
tag or another valid Hex tag.
Tone Volume