NCR 7800 - Bar Codes - 3; Interleaved 2 of 5; Bar Code Length

%DU&RGHV
 8VHUV*XLGH
Bar Codes - 3
Contains parameters for Interleaved 2 of 5 bar codes.
This function is disabled by scanning the
Hex 0
tag and
enabled by scanning the
Hex 1
tag. The default is to enable
reading.
If enabled, you can program the following parameters.
Selects the method for determining if an Interleaved 2 of 5 bar
code is a valid length. The Range Check method identifies a
length range by specifying the minimum and maximum
number of characters. The Specific Check method identifies
two specific bar-code lengths by specifying the number of
characters in each. With this option, the number of characters
in all Interleaved 2 of 5 bar codes must be one of the two
numbers. Scan the
Hex 0
tag to use the Range Check method
or scan the
Hex 1
tag to use the Specific Check method. The
default is the Range Check method.
Interleaved 2 of 5
Bar-Code Length