NCR 7800 - Value 1 and Value 2; Check Digit Present; Transmit Check Digit

%DU&RGHV
8VHUV*XLGH 
Specifies the valid Interleaved 2 of 5 bar code lengths. Use
this option with the Bar-Code Length parameter described in
the previous section. If you select the Range Check method,
Value 1 specifies the minimum number of characters in a
valid Interleaved 2 of 5 bar code, and Value 2 specifies the
maximum number of characters. If you select the Specific
Check method, Value 1 contains one specific number of
characters, and Value 2 contains another.
Accepted values for Value 1 and Value 2 are 4 to 54 readable
characters. The number of readable characters must be an
even number; if you specify an odd number, it is rounded
down one. Each value is input using two Hex tags. The first
can be
Hex 0
through
Hex 5
and the second
Hex 0
through
Hex 9
. The default for Value 1 is 08; the default for Value 2 is
16.
Determines if the bar code must contain a correct check digit
to be identified as valid. If enabled, the bar code is ignored if
a check digit is not present. Scan the
Hex 0
tag to disable this
option or scan the
Hex 1
tag to enable it. Disable is the
default.
Determines whether the check digit is sent to the host
terminal or PC. Scan the
Hex 0
tag to disable this option or
scan the
Hex 1
tag to enable it. The default is to disable
sending the check digit.
Value 1 and Value 2
Check Digit Present
Transmit Check Digit