NCR 7800 - Page 48

3DUDPHWHU3URJUDPPLQJ
 8VHUV*XLGH
7DJ )XQFWLRQ ,QGLFDWLRQ
'HIDXOW
Sets unit to standard default mode. Scan tag
immediately after applying power. The
configuration default will displayed.
Short beep - good read
Tone - Four quick beeps from
low to high frequency
3URJUDPPLQJ0RGH
Sets unit to base state for programming. Scan
tag immediately after applying power, or
after scanning the Default tag.
Short beep - good read
In Base Programming state -Long
and short beep
(QG
Ends certain input sequences. This tag is not
used often since the programming mode
determines the end of most input sequences.
Short beep - good read
6DYHDQG5HVHW
Saves programmed parameters and restarts
the unit. Used in the base state of the
Programming Mode.
Short beep - good read
Tone - Four quick beeps from
low to high frequency
$ERUW
If scanned in the base programming state, the
programming session is terminated. No
previously entered parameters are saved.
If scanned while entering parameters for a
specific programming mode, all parameters
entered up to this point are saved, and the
unit goes to the base programming state.
Short beep - good read
Tone - Four quick beeps from
low to high frequency
Short beep - good read
+H[+H[)
Provide programming selection. Hex 0: short, high frequency
beep.
Hex 1 - Hex F: Beeps tag value.
Multiples of 4 are short beeps
grouped together. Others are
longer. Example: Hex D is 3 sets
of 4 short beeps followed by 1
longer beep.