NCR RealPOS 60 - Page 39

Hardware Disassembly 17
18. InstalltheCoolingSolutionAssemblyontheMotherboard.
a. PositiontheassemblyovertheCPUandtightenthesixspring‐loadedscrews.
Note: Useasequentialrotatingpatternwhenlooseningthespring‐loaded
screws.TighteneachscrewalittleatatimetoevenlyraisetheHeatsinkfrom
theCPU.
b. Securetheassemblyto
thechassis(2screws).
Note: Afterpoweringuptheterminal,re‐flashtheBIOStoensurethelatestversion
isinstalledandverifythattheterminalisfullyfunctional(seetheBIOSUpdating
ProcedureschapterintheNCRRealPOS60UserGuide(B00500002011).
28751a
28749a
Screws