To Next Page

To Previous Page

Chapter 2: Hardware Installation

Installation Restrictions

• Before installing the NCR RealPOS X-Series Display, read and follow the guidelines

in the RealPOS X-Series Displays (5968/5985) Site PreparationGuide (BCC5-0000-5292)

and the NCR Workstation and Peripheral AC Wiring Guide (BST0-2115-53).

• Install the display near an electrical outlet that is easily accessible. Use the power

cord as a power disconnect device.

• Do not permit any object to rest on the power cord. Do not locate the display

where the power cord can be walked on.

• Use a grounding strap or touch a grounded metal object to discharge any static

electricity from your body before servicing the display.

Caution: This unit contains hazardous voltages and should only be serviced by

qualified service personnel.

Caution: This device should only be powered by a power supply source which meets

Safety Extra Low Voltage (SELV) and LPS (Limited Power Source) requirements per

UL1950, IEC 950, and EN 60 950. The power source must be certified by the appropriate

safety agency for the country of installation.

Caution: Use a grounding strap when installing this feature.

Other manuals for NCR RealPOS X Series

Questions and Answers:

Need help?

Do you have a question about the NCR RealPOS X Series and is the answer not in the manual?

General