2-72 Hardware Installation
Powering Up the Terminal
1. After installing the terminal, power up the system by briefly pressing the Power
Switch. Release the Power Switch when the green LEDturns on.
The system installs the system devices, system settings, and then reboots to continue
setup. Complete the System Setup. This varies from OS to OS but the following is
typical.
2. The initial setup procedures are performed:
• Starting Windows
• Preparing the computer for first time
• Checking video performance
3.
Accept the License Terms Agreement.
Note: Depending on the installed operating system and the selected settings, the
amount of time it takes to boot up may vary.
To Next Page
Loading...
Need help?
General
