NEC ELECTRA ELITE IPK II - Figure 5-1 Connecting the ESI Using Twisted 2-Pair Cable; Table 5-4 Electra Elite;Dterm Series E Multiline Terminal Loop Resistance and Cable Length; Table 5-5 Cable Connection between the Analog Port and the Single Line Equipment; Table 5-6 Cabling Requirements

174 pages

To Next Page

To Previous Page

Document Revision 1 Electra Elite IPK II

5 - 2 Hardware Specifications

SECTION 3 CABLING REQUIREMENTS AND SPECIFICATIONS

This section provides cabling requirements and specifications for various equipment

used in the Electra Elite IPK II system.

Figure 5-1 Connecting the ESI Using Twisted 2-Pair Cable provides a diagram of the

KSU connected with each of the Multiline Terminals and Single Line Telephones by a

separate twisted 1-pair cable or 2-pair cable (only for Multiline Terminals).

Refer to the following tables for cabling requirements and specifications.

Table 5-3 D

term

Series i or D

term

IP Terminal Loop Resistance and Cable Length

Table 5-4 Electra Elite/Dterm Series E Multiline Terminal Loop Resistance and

Cable Length

Table 5-5 Cable Connection Between the Analog Port and the Single Line

Equipment

Table 5-6 Cabling Requirements

Figure 5-1 Connecting the ESI Using Twisted 2-Pair Cable

Multiline Terminal

Twisted 2-Pair Cable

ESI

RJ-11

Other manuals for NEC ELECTRA ELITE IPK II