NEC ELECTRA ELITE IPK II - Section 8 Network and Control

Document Revision 1 Electra Elite IPK II
5 - 14 Hardware Specifications
SECTION 7 OUTSIDE LINE TYPES
The following outside lines can be used with the Electra Elite IPK II system.
J 2-wire, Loop Start or Ground Start Trunks
J 2-wire, 2-way DID Lines (Dial Pulse or DTMF)
J 4-wire, E&M Tie Lines (Type I or V, Dial Pulse, or DTMF)
J Digital Trunk T1/FT1 (Loop Start, Ground Start, Tie Line (E&M), or DID
Signaling)
J ISDN-BRI Trunks
J ISDN-PRI Trunks
J VoIP Trunks (Internet Protocols)
SECTION 8 NETWORK AND CONTROL
8.1 Transmission, Network, and Control Specifications
8.1.1 Transmission
H Data Length:
From Multiline Terminal to ESI(8)-U( ) ETU: 23 bits
From ESI(8)-U( ) ETU to Multiline Terminal: 23 bits
H Data Transmission Rates:
Between ESI(8)-U( ) ETU and Multiline Terminal: 184K bps
(voice and signaling)
H Scanning Time for each Multiline Terminal: 32 ms.
8.1.2 Network
Time Division Multiplexing (TDM) allows transmission of a number of
separate data and voice simultaneously over one communications
medium. The information below indicates the specifications the
Electra Elite IPK II system uses for switching, clock, data bus,
timeframe.
H TDM Switching: PCM (µ Law)
H TDM Clock: 2.048 MHz
H TDM Data Bus: 8 bit
H TDM Timeframe: 125 µs.