4-10 Linux Setup
Step C-1: Set Dual LAN Card Configuration
LAN configuration is not set to Linux for NEC Express5800/ft series preinstalled to the hard disk
drive of the NEC Express5800/ft series, or after Linux for NEC Express5800/ft series is reinstalled.
If you use a network, you need to set dual LAN card configuration.
The NEC Express5800/ft series builds a dual LAN card configuration by using “Stratus emb-82559
10/100 Enet Adapter” (100Base) and “Stratus emb-82544GC Copper Gigabit Adapter” (1000Base)
mounted as standard on the PCI module.
The following is a description of setting 100Base built-in LAN card.
For the setting of 1000Base built-in LAN card, perform the following by changing “7” used for slots
and commands on the description to “4”.
TIPS: To set dual LAN card configuration, you need to log in as a root user.
1. Log in to the system as a root user.
2. Execute the following command to check if the indication of LAN card appears on the slot
7.
>vndctl status
-Virtual Network Status-
virtual status ipconf slot real(s)
slot real status link
1 left -
right -
2 left -
right -
3 left -
right -
4 left gb01.03.0 -
right gb40.03.0 -
5 left -
right -
6 left -
right -
7 left epro01.06
right epro40.06
3. Execute the following command to add the LAN card of the slot 7 to the VND list.
>vndctl add 7
To Next Page
Loading...
