4-18 Linux Setup
Stop the SCSI disk
To stop the SCSI disk manually, use ftdiskadm.
The following is an example of procedure to stop the SCSI disk using ftdiskadm.
<Example>
Command action
1 => SCSI
2 => RAID
3 => Environment
9 Quit
Command: 1
Command action
1 Status(All Disks)
2 Status(System Disks)
3 Status(Extended Disks)
4 Bring Up
5 Bring Down
9 <= RETURN
Command: 5
[Bring Down]
* Which disk(s)? [‘?’ for help] => (10.1)t0I5 (Note 1)
* Bringing down: ‘(10.1)t0I5 [d0h2c0tI5]’ [y/n]
<<<Check the status of SCSI disk>>>
Note 1: You can list the disk specification methods by entering “?”.
“*” can be used in the TARGET section, LUN section, serial number, device name and it
fits to all candidates. In addition, you can put the numbers inside “[ ]” (e.g.,
[<num1>,<num2>]), or specify the range of the numbers (e.g., [<num3>,<num5>]).
To Next Page
Loading...
