NEC Express5800 Series - Page 92

1. System Utilities
Express5800/R120h-1E, R120h-2E Maintenance Guide
92
Chapter 2 Useful Features
(c) iSCSI Configuration Menu
When you select System Configuration > BIOS/Platform Configuration (RBSU) > Network Options > iSCSI
Boot Configuration from the System Utilities, the iSCSI Boot Configuration menu appears.
For details about the options, see the table below.
Option
Parameter Description
iSCSI Initiator Name String of 4 to 223 alphanumeric
characters
The worldwide unique iSCSI Qualified Name (IQN)
of the iSCSI initiator. Only IQN format is accepted.
EUI format is not supported. For example:
iqn.2001-04.com.example:uefi-13021088
Add an iSCSI Attempt
-
Add an iSCSI Attempt
Delete iSCSI Attempts
-
Deletes one or more iSCSI attempts.
iSCSI Attempts
-
-
AttemptX
-
-
[ ]: Default setting
Add an iSCSI Attempt Menu ①.
When you select System Configuration > BIOS/Platform Configuration (RBSU) > Network Options > iSCSI
Boot Configuration > Add an iSCSI Attempt from the System Utilities, the Add an iSCSI Attempt menu
appears.
This menu increases or decreases, depending on the installed status of the network interface card.
For details about the options, see the table below.
Option
Parameter Description
(UEFI LAN Driver name)
Example:
SlotX PortY : Intel(R)
Ethernet Controller
- -
i.
(UEFI LAN Driver) Menu
When you select System Configuration > BIOS/Platform Configuration (RBSU) > Network Options > iSCSI
Boot Configuration > Add an iSCSI Attempt > (UEFI LAN Driver) from the System Utilities, the (UEFI LAN
Driver) menu appears.
For details about the options, see the table below.
Option
Parameter Description
iSCSI Attempt Name [1] A descriptive name for this iSCSI attempt
configuration.
iSCSI Boot Control [Disabled]
Enabled
Enabled for MPIO
Use this option to set the iSCSI mode for this attempt,
or to enable the Multi-Path I/O (MPIO) capability.
IP Address Type [IPv4]
IPv6
Auto
Use this option to configure the iSCSI initiator IP
address type (IPv4 or IPv6). In Auto mode, the iSCSI
connection uses the IPv4 stack, and if the connection
fails, is re-attempted using the IPv6 stack.
Connection Retry Count 0-16
[3]
The number of times to retry the iSCSI connection.
Valid values are between 0 and 16. A value of 0
means no retries.
Connection Timeout 100-[20000] The iSCSI connection timeout value in milliseconds.
Valid values are between 100 milliseconds and 20
seconds (20000 milliseconds).(def:1000)
Initiator DHCP Config
(Check Box)
Enables or disables configuring the iSCSI initiator IP
address from DHCP.(def:0)