NEC Express5800 Series - Embedded Device Information

1. System Utilities
Express5800/R120h-1E, R120h-2E Maintenance Guide
127
Chapter 2 Useful Features
Embedded Device Information
1.2.4
(1)
(Embedded RAID) Menu
When you select System Configuration > (Embedded RAID) from the System Utilities , the (Embedded
RAID) menu appears.
For details about the options, see the table below.
Option Parameter Description
Controller Information
-
Provides the information of the controller like
PCIe Bus :Device:Function, Firmware Revision,
UEFI Driver Version, Controller Temperature etc.
Enable/Disable Smart array
Debug Messages
(Check Box)
Select or deselect the check box to enable or
disable the Smart array debug message.
Configure Controller Settings
-
Configures the supported controller settings,
advanced controller settings(if applicable) and
clear the controller's current configuration.
Array Configuration
-
Creates new array(s) from the list of drives
available and manages the existing arrays.
Disk Utilities
-
Displays the list of drives that are connected to
the controller and allows the user to perform
certain operations on the disks available.
Exit and launch Smart
Storage Administrator(SSA)
-
Launch the Smart Storage Administrator (SSA) to
configure RAID levels.
(2)
(Embedded LOM) Menu
When you select System Configuration > (Embedded LOM) from the System Utilities, the (Embedded LOM)
menu appears.
For details about the options, see the table below.
Option Parameter Description
Firmware Image Menu
-
Firmware image information.
Blink LEDs [0]-X Blink LEDs for a duration up to 15 seconds.(def:0)
Chip Type (Display only) Shows the type and revision number of the chip.
PCIe Device ID (Display only) Shows the PCIe device ID.
PCIe Address (Display only) Shows the "PCIe_bus_number:device_
number:function_number” of this device.
Link Status (Display only) Shows the link status.
MAC Address (Display only) Shows the fixed MAC address.
Virtual MAC Address (Display only) Shows the virtual MAC address.
[ ]: Default setting