3. Installing User Supportware 2
15
Installing User Supportware 2
In the "Ready to Install the Program" screen, click [Install].
The installation will begin.
When installation has been completed, the "InstallShield Wizard Completed" screen is
displayed.
Click [Finish].
A message prompting you to restart the system will be displayed.
Click [Yes].
Windows will be restarted.
When the desktop screen of Windows is displayed, click [Start] → [Run:] → [CD-ROM drive
name + SETUP.EXE (e.g., Q\:SETUP.EXE)], followed by [OK]. The menu screen of the User
Supportware 2 CD-ROM will be displayed again.
7
Important
• Immediately after installation has been started, the following screen may be displayed.
For Windows XP For Windows 2000
If the above screen is displayed, click [Continue Anyway] when Windows XP is used.
Click [Yes] when Windows 2000 is used.
NEC has confirmed that the driver of this software correctly runs on Windows XP and
Windows 2000.
• When you install the driver, the personal computer screen will go blank momentarily.
Click
Click
8
9
To Next Page
Loading...
