7. Setting the LAN Setting of Projector
27
Setting the LAN Setting of Projector
When connecting a LAN cable to the LAN port of the projector, select the "Built-in" page of
"LAN Mode".
Flow of setting
7-2. Wired LAN
Step 1 Display "Built-in" page of "LAN Mode".
Step 2 Select "Profiles".
Step 3 Enable or disable "DHCP".
If "Disabled" (without check mark)
Step 4 Input "IP Address".
Step 5 Input "Subnet Mask".
Step 6 Input "Gateway".
Step 7 Input "DNS Configuration".
Step 8 Reconnect the network.
Step 9 Finalize the setting.
If "Enabled" (with check mark)
To Next Page
Loading...
