NEC LT265 - Power Cable Connection; Connecting the Power Cable Safely

7. Setting the LAN Setting of Projector
31
Setting the LAN Setting of Projector
When inserting the wireless LAN card into the PC card slot of the projector, use the "PC
Card" page of "LAN Mode".
 Flow of Setting
7-3. Wireless LAN
If "Enabled" (with check mark)
6-1. Setting of "Network Type".
Select SSID in "Site Survey".
Input "SSID" (if necessary).
Select "Mode" (if necessary).
6-2. Setting of "WEP"
Select the number of bits of "WEP".
Select "Key Select".
Set "Key 1 to Key 4".
Step 7 Finalize "Advanced".
Step 8 Reconnect the network.
Step 9 Finalize the setting.
Step 1 Display "PC Card" page of "LAN Mode".
Step 2 Select "Profiles".
Step 3 Enable or disable "DHCP".
If "Disabled" (without check mark)
Step 4 Input "IP Address".
Input "Subnet Mask".
Input "Gateway".
Step 5 Input "DNS Configuration".
Step 6 Setting of "Advanced".
If "Easy Connection" is selected