7. Setting the LAN Setting of Projector
28
Setting LAN
Select "Profiles".
"Profile 1" or "Profile 2" can be stored in the memory of the projector as the setting of LAN when
the LAN port of the projector is used.
<1> Press the button once to highlight the "Profiles" field and press the
button.
<2> Use the button to highlight "Profile 1" or "Profile 2", and press
the button.
Set "DHCP".
Check this check box if the network to which the projector is to be connected automatically
assigns the IP address via the DHCP server.
<1> Press the button once to highlight the "DHCP" check box and press
the button.
A check mark will be placed.
• To clear the check box, press the button once again.
• If "DHCP" is checked, move the highlight to "Reconnect" and press the button
after making "DNS Configuration".
• If "DHCP" is not checked, input "IP Address", "Subnet Mask", "Gateway", and "DNS Con-
figuration" as necessary. After each item has been set, move the highlight to "Reconnect"
and press the button.
1
2
To Next Page
Loading...
