3. Installing User Supportware 2
17
Installing User Supportware 2
Installing Viewer PPT Converter 3.0
Click [Install Ulead Photo Explorer 8.0].
The "Welcome to Ulead Photo Explorer 8.0 SE Basic Setup" screen will be displayed.
Click [Next].
The "License Agreement" screen will be displayed.
Carefully read the contents of the "End User License Agreement".
If you agree to the End User License Agreement, click [Yes].
The "User Information" screen will be displayed.
Input [Name:] and [Company:], and click [Next].
The "Choose Destination Location" screen will be displayed.
• This software does not require you to input the "Serial Number".
• After that, follow the instructions on the screen to continue with the installation.
• When installation is complete, the menu screen of the User Supportware 2 CD-ROM is dis-
played again.
Click [Installing Viewer PPT Converter 3.0] on the menu screen.
Preparation for the installation will begin.
When preparation is complete, the "Welcome to the InstallShield Wizard for Viewer PPT
Converter 3.0" screen is displayed.
• After that, follow the instructions on the screen to continue the installation.
• When installation is complete, the menu screen of the User Supportware 2 CD-ROM is dis-
played again.
2
3
4
5
1
• When Viewer PPT Converter 3.0 has been installed, once start Viewer PPT Con-
verter 3.0 once with the privilege used for installation. Then exit from Viewer PPT
Converter 3.0 without doing anything.
•Starting
Click Window's [Start] → [All Programs] → [NEC Projector User Supportware 2] →
[Viewer PPT Converter 3.0] → [Viewer PPT Converter 3.0], in that order.
To Next Page
Loading...
