NEC LT265 - Fine-Tuning Image Display; Adjusting Image Size and Focus

7. Setting the LAN Setting of Projector
37
Setting the LAN Setting of Projector
<2> Use the button, move the highlight to a character, and press
the button.
<3> Repeat step <2> above to input the encryption key.
The character will be input.
• Each button on the software keyboard has the following function.
• " " " " •••••••••••• Move the character insertion position in the encryption key field
to the left or the right.
• "MODE" ••••••••••••• Selects uppercase, lowercase, or special characters.
• "SP" •••••••••••••••••• Inputs space.
• "BS" •••••••••••••••••• Deletes one character to the left of the character insertion posi-
tion in the encryption key field.
• [OK] •••••••••••••••••• Finalizes the input character and closes the software keyboard.
• [Cancel] ••••••••••••• Cancels the input character and closes the software keyboard.
• "HEX" or "ASCII" •• Selects alphanumeric character input or hexadecimal number
input.
• When "HEX" is displayed, alphanumeric characters (ASCII)
can be input.
• To input hexadecimal numbers, move the highlight to "HEX"
and press the button. "ASCII" will be displayed
instead of "HEX", and hexadecimal numbers can be input.
• When hexadecimal numbers can be input, "0x" is automati-
cally displayed at the beginning of the input field.
Finalize "Advanced".
<1> Use the button to highlight [OK] and press the button.
The "PC Card" page will be displayed again.
Reconnect the network.
<1> Use the button to highlight "Reconnect" and press the
button.
Finalize the setting.
<1> Use the button to highlight [OK] and press the button.
The contents of the setting will be stored in the memory of the projector.
13
14
15