Using the NEC MobilePro 4-5
Follow these steps to enable the Suspend switch.
1.
Tap Start, Settings, then select Control Panel.
2.
Double tap the MobilePro Settings icon to launch the dialog box.
Be sure to select the “LCD Suspend/Resume” tab.
3.
Select either “Enable suspend while on Battery Power” or “Enable
suspend while on External Power,” or both, to enable the display
linkage switch.
Note
While running on battery power your NEC MobilePro will not
automatically suspend during synchronization, while running on battery
power, unless the battery charge is at a very low status. You may want to
connect your MobilePro to an AC power source before synchronizing with
your host PC.
Using the Keyboard
The NEC MobilePro keyboard is equipped with many features including:
! Application shortcut keys
! Brightness up/down keys
! Cursor control keys
! Control keys
! Windows key
Feature keys are located as shown in the following figure. Key operations
are described after the figure.
To Next Page
Loading...
