NEC MultiSync CB651Q - Connecting a Personal Computer; Connecting a Player or Computer with HDMI; Connecting a USB Device

To Next Page

To Previous Page

English-19

English

Connecting a Personal Computer

Connecting your computer to your LCD monitor will enable you to reproduce your computer’s video signal output.

Some display cards may not be able to support the required resolution for proper image reproduction.

Your LCD monitor shows proper image by adjusting the factory preset timing signal automatically.

Resolution

Scannibg frequency

VGA

HDMI

Horizontal Vertical HDMI (4k/60Hz)

640 x 480 31.5 kHz 60 Hz Yes Yes

800 x 600 37.9 kHz 60 Hz Yes Yes

1024 x 768 48.4 kHz 60 Hz Yes Yes

1280 x 720 45.0 kHz 60 Hz Yes No

1280 x 768 47.8 kHz 60 Hz Yes Yes

1280 x 960 60.0KHz 60 Hz Yes Yes

1280 x 1024 64.0KHz 60 Hz Yes Yes

1360 x 768 47.7KHz 60 Hz Yes Yes

1440 x 900 55.9KHz 60 Hz Yes Yes

1680 x 1050 65.3KHz 60 Hz Yes Yes

1920 x 1080 67.5KHz 60 Hz Yes Yes

3840 x 2160 67.4KHz 30 Hz No Yes

3840 x 2160 135KHz 60 Hz No Yes

Connecting a Player or Computer with HDMI

• Please use an HDMI cable with the HDMI logo.

• It may take a moment for the signal to appear.

• Some display cards or drivers may not display an image correctly.

• Please check display card when image is compressed with 1920 x 1080.

• To output HDMI audio, set [HDMI1], [HDMI2] or [HDMI3] at INPUT in the OSD or choose [HDMI1], [HDMI2] or [HDMI3] by

the remote control INPUT button.

• If the monitor’s main power is turned on after a connected computer is turned on, sometimes images are not displayed.

In this case, please turn off the computer then turn it on again.

Connecting a USB device

USB: USB downstream port.

Connect USB devices such as mobile hard disk, U disk, USB keyboard and mouse, USB drives, etc.

please use this port.

• Please make sure the connector shape and orientation is correctly aligned when connecting the USB device or cable.

• Please refer to the specications page for power supply information (see page 69, page 70 and page 71).

• When you use the USB port for power supply, please use a USB cable that supports 500mA.

• Do not bind the USB cable. It may cause heat or re.

Related product manuals