4-3
2.2.2 Factory mode
At the time of adjustment of this model, a suggestion may be given to enter the user (factory) mode. This will
be explained below.
(1) User mode:
1) Press the power Key and verify that LED is green. Press MENU to into OSD MENU.
2) Select COLOR and into color adjust.
3) PRESET1 and PRESET2 is factory setting value user cannot adjust it.
4) Select any one of R G B and into user mode color adjust, press [+] and [-] to adjust color.
(2) Factory mode:
1) Power off the monitor.
2) Press the MENU : AUTO and POWER key at the same until LED is green entered into the Factory
mode.
3) Press MENU key to display the OSD menu, and select the PRESET2 color temperature. Please do not
adjust it because the value is factory value.
4) Select MAIN MENU → MISC → INFORMATION → [+] or [-] key and into HOURS RUNNING mode. It
will show :
a. USER ON : It means monitor used time by user.
b. USER OFF : It means monitor standard by (power saving) and off time by user.
c. FAC. ON : It means monitor used time since assembled in factory.
d. FAC. OFF : It means monitor standard by (power saving) and off time since assembled in factory.
e. CPU TYPE : MTV112MN32
f. CPU CODE : Code of CPU
g. CPU VER. : CPU update date.
Note: To return to user mode from factory mode, just power OFF → ON again.
To Next Page
Loading...
Need help?
General