English−12
4. Connect the supplied power cord
Please refer to the “Important Information” section of this user’s manual for proper selection of an
AC power cord.
Please refer to “CAUTION 1”.
• The monitor should be installed close to an easily accessible power outlet.
Please make sure that enough power is supplied to the monitor. Please refer to the “Power Supply” in the
specication (See “M751” on page 81 and “M861” on page 82).
Screw
Clamp
5. Cable information
Use the provided specied cables with this product so as not to interfere with radio and television reception.
For USB, please use a shielded signal cable with ferrite core.
For HDMI, RS-232C and DisplayPort, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
6. Turn on the power for the monitor and the external equipment
Switch on the monitor power rst.
7. Operate the attached external equipment
Select the input source for the attached equipment to show the image signal on screen.
If you have selected anything other than HDMI1 for the input, if the main power is turned off, DDC communication
will not be available.
8. Adjust the sound
Make volume adjustments when required.
9. Adjust the picture settings (see page 90)
If necessary, make adjustments to the backlight, colors, contrast, and image position in the OSD PICTURE menu.