English−26
%
For use with an Option Board. The function depends on
which Option Board is installed in the monitor.
^
Mutes the monitor’s audio and video output.
Press it again to unmute the monitor’s audio and video
output. See “MUTE SETTING” on page 107 for details.
&
Cycles through the picture modes [NATIVE], [RETAIL],
[CONFERENCING], [HIGHBRIGHT], [TRANSPORTATION]
and [CUSTOM]. See page 38.
*
Cycles through the picture aspect ratios [FULL], [WIDE]*,
[1:1], [ZOOM] and [NORMAL]. See page 39.
*: HDMI1, HDMI2, OPTION (TMDS)*
2
, COMPUTE MODULE*
1
inputs only.
*
1
: This input is available when the optional Raspberry Pi Compute Module
Interface Board and Raspberry Pi Compute Module are installed.
*
2
: This function depends on which Option Board is installed in the monitor.
(
Selects the audio input source [IN1], [IN2], [HDMI1],
[HDMI2], [DisplayPort1], [DisplayPort2], [OPTION]*
1
and
[COMPUTE MODULE]*
2
.
*
1
: This function depends on which Option Board is installed in the monitor.
*
2
: This input is available when the optional Raspberry Pi Compute Module
Interface Board and Raspberry Pi Compute Module are installed.
See page 84.
)
ON/OFF button: Activates/deactivates still picture mode.
CAPTURE button: Captures a still picture.
• This function is released if any following
functions is changed: [ASPECT], [MULTI
PICTURE], [TILE MATRIX], [MOTION] in
[SCREEN SAVER], POINT ZOOM, [IMAGE
FLIP], [QUICK INPUT CHANGE], [OVERSCAN],
[DUAL DAISY CHAIN MODE], if you change
the [AUDIO INPUT] setting, or set [DisplayPort
VERSION] of [DisplayPort1] to [1.4] while STILL
is active.
• This function is disabled when one of the
following functions is active: [MULTI PICTURE],
[MOTION] in [SCREEN SAVER], POINT ZOOM,
[TILE MATRIX], [IMAGE FLIP], [QUICK INPUT
CHANGE], [DUAL DAISY CHAIN MODE],
[ROTATE] or if input is set to [DisplayPort1] and
the [DisplayPort VERSION] is set to [1.4].
• If the input signal is [OPTION], this button’s
action depends on which Option Board is
installed in the monitor.
-
Selects the active picture when Multi Picture Mode is
enabled. See page 96.
=
ON/OFF button: Turns Multi Picture Mode on and off.
MODE button: Switches between the available Picture-
In-Picture (2PIP) and Picture-By-Picture (2PBP or 4PBP)
modes.
CHANGE button: Swaps the selected inputs between
Picture 1 and Picture 2 when 2PIP is set.
For more information see page 96.
If you press SET/POINT ZOOM button while Multi
Picture is ON, you can change the active picture’s
picture size.
q
Toggle switches between [H FLIP], [V FLIP], [180° ROTATE]
and [NONE]. See page 95.
w
For use with an Option Board. The function depends on
which Option Board is installed in the monitor.
e
Activates the REMOTE ID function. See page 61.
To Next Page
Loading...
