English−93
PICTURE MENU
ADVANCED
UHD UPSCALING Achieves high-denition effect.
SHARPNESS
Adjusts the crispness of the image. Press or button to adjust.
ASPECT Select the aspect ratio of the screen image.
NOTE: • When starting tile matrix in multi-monitor installations, if the [ASPECT] is [ZOOM] it will be
changed to [FULL] before tile matrix starts. After tile matrix is complete, the aspect will return
to [ZOOM].
• If you change [H POS] and [V POS] settings with a reduced image, the image will not be
changed.
• The [ASPECT] automatically changes to [FULL] when the [SCREEN SAVER] starts. When the
[SCREEN SAVER] stops, the [ASPECT] returns to its previous setting.
• This function is not available when [MOTION] in [SCREEN SAVER] is active.
• The POINT ZOOM function has limitations when [ASPECT] is changed. Please refer to
Point Zoom on page 40.
• [ZOOM] is not available for an image with a DisplayPort input 4K (60 Hz) 10bit.
• If the [ASPECT] is [ZOOM] while tile matrix is active, when tile matrix is released, the
[ASPECT] will be [ZOOM].
NORMAL Shows the aspect ratio as it is sent from the source.
FULL Fills the entire screen.
WIDE Expands a 16:9 letterbox signal to ll the entire screen.
1:1 Shows the image in a 1 by 1 Pixel format. (If the input resolution is higher than the recommended
resolution, the image will be scaled down to t the screen).
ZOOM Expands/reduces the image.
NOTE: The areas of the expanded image that are outside of the active screen area are not shown.
The reduced image may have some image degradation.
ZOOM Maintains the aspect ratio while zooming.
HZOOM Horizontal zoom value.
VZOOM Vertical zoom value.
H POS Horizontal position.
V POS Vertical position.
ADAPTIVE CONTRAST
HDMI1, HDMI2, OPTION (TMDS)*
2
,
COMPUTE MODULE*
1
inputs only
Sets the level of adjustment for dynamic contrast.
If HIGH is set, the image is shown clearly but it makes brightness unstable due to the wide gap in contrast
variation.
NOTE: When [SPECTRAVIEW ENGINE] is set to [ON], this function is disabled.
UNIFORMITY This function improves the color reproduction and evens out the non-uniformity in luminance of the
monitor.
NOTE: When [SPECTRAVIEW ENGINE] is set to [ON], this function is disabled. Instead, [UNIFORMITY]
is enabled and saved in the SpectraView [PICTURE MODE] settings. See page 90.
AUTO DIMMING Adjusts the backlight of the LCD automatically depending on the amount of ambient light.
AUTO BRIGHTNESS Adjusts the brightness level according to the input signal.
NOTE: • [MODE1] is disabled when [AMBIENT LIGHT SENSING] function is set to [ON].
• When [SPECTRAVIEW ENGINE] is set [ON], this function is disabled.