NEC NC1700L - Removing and Mounting the Front Cover

45
Before Setting Up Your Projector and the Chiller Unit
1-5-1. Removing and Mounting the Front Cover
NOTE
When removing (mounting) the front cover, return the lens position to the center before turning off the projector
power (page 100). If you do not return the lens position to the center, the lens may interfere and prevent you from
removing (mounting) the front cover.
Preparation: Phillips head screwdriver (No.2) and cover key (attached goods)
1
Remove the Air inlet cover.
Slide the Air inlet cover in the direction of the arrow to remove.
Handle
2
Loosen two screws securing the front cover until the Phillips screwdriver goes into a freewheeling
conditions.
The screw is not removable.