NEC NC1700L - AC Power Work Specifications (Projector)

52
Setting Up Your Projector and Chiller Unit
2-3-1. AC Power Work Specications (Projector)
AC power supply equipment
Do not use any voltage other than those shown below for the AC power supply connected to the projector.
200–240V AC, single phase, power, 50/60Hz
AC power supply cable for the projector
The projector is equipped with an IEC60320 C20 inlet to connect an AC power supply cable. Use an IEC60320 C19 compliant
AC power cable connector and ensure that the connector meets the following current capacity specifications.
Power supply voltage Projector input current Power cable current capacity
AC 200–240V 10.7A (MAX) 250V 16A or higher
Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as shown in
the following table.
NOTE
For users in North America
Use a power cable no longer than 4.5m/14.76 ft according to National Electrical Code.
Cable
Plug
Connector
Germany
Plug Cable Connector
CEE 7
H05VV-F 3G1.5 IEC 320 C19
USA
Plug Cable Connector
NEMA 6-15P
SJT 3 x AWG 14 IEC 320 C19
Japan
Plug Cable Connector
JIS C 8303
VCTF 3 x 2.0mm IEC 320 C19