89
4. LCD Menu
This chapter describes the menus displayed in the LCD screen on the projector’s control panel and their functions. For basic
operations of menus, refer to the projector’s operation manual.
4-1. List of Menu
Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used. If you are logged in to the
projector with Installation privileges, you cannot use [FactoryDefault] - [LAN] (page 93).
Main menu Submenu Description
Reference
page
Title Select “Title Memory Name” Selects the title of the signal to be projected. 91
TEST Pattern Selects the test pattern to be projected. 91
Configuration Light Setup Adjust Adjusts light brightness. 92
Lens Control Lens Position Adjusts the position of the projected screen. 92
Focus Zoom Adjusts the size and focus of the projected screen. 92
Reset (FactoryDefault) Returns the settings to their default values. Selects between
preset buttons and titles only, LAN settings only and all settings.
93
Filter Cleaning Initializes the air filter usage time (for confirming the filter
cleaning time).
93
(Fan Usage) Initializes the usage time of the fan. 94
(Light) Initializes the usage time of the light source. 94
(Phosphor) Initializes the usage time of the phosphor. 94
(Diffuser) Initializes the usage time of the diffuser. 94
(Chiller) Initializes the usage time of the chiller unit. 94
(Chiller Fan) Initializes the usage time of the chiller unit fan. 95
(Douser Count) Resets the number of times the douser has been used. 95
(Setup) Douser Setup Sets the douser open/close state. 95
Panel Key Lock Locks the buttons on the projector’s control panel so that they
cannot be operated.
96
Auto Key Lock Enables or disables Auto Key Lock. 96
3D Connector Sets the signal input terminal for a 3D image system (3D terminal
or GPI/O terminal).
Sets the video input port for 3D video systems.
96
Off Timer Sets the time until the projector power is turned off automatically. 97
Message Sets the time to display the message indicating the light
replacement cycle.
97
Silent Mode Selects whether to use the status indicator, buzzer, indicators on
the control panel and backlight.
98
Installation
(Note)
(Option Slot) Configures the device installed in slot (only when the projector is
in standby mode).
99
(Orientation) Sets the projection method. 99
Lens Type (Note) Sets the type of lens (supports or does not support the lens
memory function) attached to the projector.
100
Lens Calibrate
(Note)
Performs calibration on lens that support the lens memory
function (only when the projector power is turned on).
100
Lens Center (Note) Moves the lens shift position to the center (only when the
projector power is turned on).
100
(Baudrate) Sets the PC control connector (RS-232) data transmission speed
(bps).
101
(Date/Time) Sets the date and time on the projector. 101
(Fan Speed Mode) Sets the cooling fan operating mode. 102
(Service Adj.) (Only when the projector is in standby mode)
This is used during shadow adjustment and lens mount
adjustment (focus balance adjustment).
102
(LD Calibrate) Performs calibration of the light module when the light module
has been replaced (only when the projector power is turned on).
102
To Next Page
Loading...
