80
Projector Adjustment and Connecting
3-2-1. Clearing tamper events
Be sure to do this while the power of the projector is on (when Power-ON).
If any tamper events have been detected by the tamper detection circuit of the projector main unit, clear the tamper events
using the following procedure.
Start clearing the tamper events
Finish clearing the tamper events
Error codes 582 and 584 have
occurred
Error code 586 has occurred
Have the tamper events been
cleared?
Step 2
Perform re-marriage using the Digital Cinema
Communicator
Step 1
Clear the “Service Door Tamper” by using the buttons
on the Control Panel.
Turn off the projector main unit, disconnect the AC
power supply, and check the “Check” items
Yes
No
No
Yes
Yes
No
To Next Page
Loading...
